For our example, this requires entering or * then 8 then the 4 digit default installer code. To program the alarm, you first must enter the installer code. Whether you have a DSC or some other alarm system, you should thoroughly read your installer and programming manuals and write down what changes you want to make before proceeding. To program the alarm panel, you specify the address or section that you want to change and then provide a new value for that address.Ĭontinuing with our DSC Alarm System Example, some of the information here will the DSC specific. This memory is identified by an address or location. With the cheaper keypads, you have to depend on a bunch of green lights to tell you what is going on.Īll configuration information in the alarm panel is saved in non-volatile memory, meaning that the data is not lost when the device loses power. With the full LCD screen, you are able to visually verify what mode you are in and what you are typing. Programming on a keypad with a LCD display is much easier than using one with only lights. At least one of your keypads should be an LCD display. Programming is done from a keypad that is connected to the main panel. You already know what you are doing and they are nothing more than reference guides. If you are setting up an alarm system on your own, expect to do lots of reading and re-reading. The installer programming manuals are much more complicated and involve setup that the homeowner is not expected to perform. The first thing to realize is that the manual that a security company gives the homeowner is not the full installers programming manual. This guide will focus those areas that are common to all systems. Programming a Home Security System / Burglar AlarmĮvery alarm system is different, but there are some basic premises that are consistent for all systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |